![]() |
![]() |
#1 |
Новый Пользователь
Регистрация: 01.06.2017
Город: Bucharest
Регион: 40
Машина: BMW E60
Сообщений: 1
![]() |
![]() Hello.
I have a simple task to achieve, I guess, but I'm stuck. I'm using the setup from the attached image. All I need to do is to read the Speed of the vehicle using data from the obd2 k-line pin, and then to send a command to blink the brake lights when a certain decrease in speed is detected (e.g. more than 2km/h/s). I can not initialize the k-line and I am not able to red anything on the serial monitor on arduino ![]() Question... Are the TX/RX pins connected as it shod on the arduino board? Thank you. Ant help would be appreciated. I need this for a school project and a have a deadline ![]() |
![]() |
![]() |
![]() |
Метки |
arduino, brake, code, k-line, speed |
Здесь присутствуют: 1 (пользователей: 0 , гостей: 1) | |
Опции темы | |
|
|