Выложу я - мануал во вложении.
Господа, никто еще не нарыл софт для управления девайсом через СОМ порт?
upd: Похоже, что софта и не существует в природе. Вот цитата из мануала:
Цитата:
Timing Setting Guide:
By connecting the PSU to a PC with RS232, with software like HyperTerminal, with the
following setting:
1200, 8, N, 1
The timing of PSU can be set as the following command sets:
(All in Hexadecimal value)
E000H: Get the all setting value:
Byte 1:
b0: Set: Auto Start Signal enabled, clear: disable.
Byte 2: A flag byte always be 0x68,
Byte 3: Delay time of Auto Start signal after ACC ON.
Byte 4: Delay time of Shut Down signal after ACC OFF.
Byte 5: Delay time of Auto Start enable again after ACC OFF.
Byte 6: Power Low Detected level, from 0 to 40, represent 10V to 13V.
Byte 7: Delay time Shut Down signal after Power low level reached.
Byte 8: Reserved.
E001H: Get the PSU status value.
E002H: Send a Power ON signal to motherboard.
E003H: Send a Power ON signal to motherboard.
E00FH: Recall all setting.
E1xxH: Set the setting byte 1 value.
E2xxH: Set the Delay time of Auto Start signal out after ACC ON.
E3xxH: Set the Delay time of Shut Down signal out after ACC OFF.
E4xxH: Set the Delay time of Auto Start signal out enable again after ACC OFF
E5xxH: Set Power Low Detected level, from 0 to 40, represent 10V to 13V, 0.075V per step.
E6xxH: Set Delay time of Shut Down signal out after Power low level reached.
|