Цитата:
Сообщение от sirota
Если честно, то я не понял, что хотите сделать то?
Или может я непонятливый такой...ночь не спал.
|
Хочу сделать - как написано в инструкции
http://www.compcar.ru/forum/showthread.php?t=3220
M2-ITX.DOC Таблица 4.1 пункт 6 Hand control.
"The power output set by the jumper wire. when it’s set in automation mode, the power supply will work according to the process of the item 1.
When it’s set to hand control mode, it controlled by external switch:
1) Ignition=OFF, Nothing happens，waiting for Ignition signal ON。
2) Ignition=ON，wait for 3-4s，open ＋5VSB output，the power supply go into sleeping mode, waiting for switch ON/OFF.
3) Ignition=ON，press the switch button one time, sends an ”ON” signal to the motherboard .The motherboard will turn ON and your system should start booting。
4) Ignition=ON, during power be in ON condition, press the switch button one time (<1s transient time). Nothing happens.
5) Ignition=ON, during power be in ON condition, press the switch button for 3-4s, then send an “OFF” signal to the motherboard, the power supply go into sleeping mode.
6) Ignition=OFF, during power be in ON condition, wait about 10s and then it turned motherboard OFF by sending a signal to the motherboard’s ON/OFF switch. Your computer should turn off gracefully. During this time, Power will still be provided for another 50s, long enough for most soft shutdown processes. In the event where the shutdown processes is hanging, power will be shutdown hard, turn off your computer’s main power source to prevent battery drain.
7） Ignition=OFF after 10s. during power be in OFF condition. Power will be shutdown include +5VSB output.
8）Go back to step 1，until ignition is turned ON again"