C:\WinAVR-20100110\bin>avrdude -F -v -p m328p -c stk500v1 -P COM27 -b 57600 -D -
Uflash:w:TouchController.hex:i
avrdude: Version 5.10, compiled on Jan 19 2010 at 10:45:23
Copyright (c) 2000-2005 Brian Dean,
http://www.bdmicro.com/
Copyright (c) 2007-2009 Joerg Wunsch
System wide configuration file is "C:\WinAVR-20100110\bin\avrdude.conf"
Using Port : COM27
Using Programmer : stk500v1
Overriding Baud Rate : 57600
AVR Part : ATMEGA328P
Chip Erase delay : 9000 us
PAGEL : PD7
BS2 : PC2
RESET disposition : dedicated
RETRY pulse : SCK
serial program mode : yes
parallel program mode : yes
Timeout : 200
StabDelay : 100
CmdexeDelay : 25
SyncLoops : 32
ByteDelay : 0
PollIndex : 3
PollValue : 0x53
Memory Detail :
Block Poll Page
Polled
Memory Type Mode Delay Size Indx Paged Size Size #Pages MinW Max
W ReadBack
----------- ---- ----- ----- ---- ------ ------ ---- ------ ----- ---
-- ---------
eeprom 65 5 4 0 no 1024 4 0 3600 36
00 0xff 0xff
flash 65 6 128 0 yes 32768 128 256 4500 45
00 0xff 0xff
lfuse 0 0 0 0 no 1 0 0 4500 45
00 0x00 0x00
hfuse 0 0 0 0 no 1 0 0 4500 45
00 0x00 0x00
efuse 0 0 0 0 no 1 0 0 4500 45
00 0x00 0x00
lock 0 0 0 0 no 1 0 0 4500 45
00 0x00 0x00
calibration 0 0 0 0 no 1 0 0 0
0 0x00 0x00
signature 0 0 0 0 no 3 0 0 0
0 0x00 0x00
Programmer Type : STK500
Description : Atmel STK500 Version 1.x firmware
Hardware Version: 2
Firmware Version: 1.16
Vtarget : 0.0 V
Varef : 0.0 V
Oscillator : Off
SCK period : 0.1 us
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.02s
avrdude: Device signature = 0x1e950f
avrdude: safemode: lfuse reads as 0
avrdude: safemode: hfuse reads as 0
avrdude: safemode: efuse reads as 0
avrdude: reading input file "TouchController.hex"
avrdude: writing flash (11266 bytes):
Writing | ################################################## | 100% 3.31s
avrdude: 11266 bytes of flash written
avrdude: verifying flash memory against TouchController.hex:
avrdude: load data flash data from input file TouchController.hex:
avrdude: input file TouchController.hex contains 11266 bytes
avrdude: reading on-chip flash data:
Reading | ################################################## | 100% 2.53s
avrdude: verifying ...
avrdude: 11266 bytes of flash verified
avrdude: safemode: lfuse reads as 0
avrdude: safemode: hfuse reads as 0
avrdude: safemode: efuse reads as 0
avrdude: safemode: Fuses OK
avrdude done. Thank you.
C:\WinAVR-20100110\bin>
И все. дальше ничего не происходит. пробовал на 2-х РАЗНЫХ ардуинах.
Как было устройство CH340 usb-serial , так и есть....
Помогите решить проблему ПЛИЗ!